Applied Element Method (AEM)
  • Home
  • Applications
    • Structural Vulnerability Assessment
    • Performance Based Design
    • Glass Performance Analysis
    • Forensic Structural Engineering
    • Demolition Analysis
    • Visual Effects
  • Publications
    • Journals
    • Conferences
    • Bullitins
    • Other Publications
  • Resources
Select Page

Experimental & Analytical Alternate Load Path Analysis for Reinforced Concrete Flat Plate Systems

by Applied Element Method | Apr 7, 2017 | Conferences

Alternative Load Path Analysis (ALPA) is becoming the most common technique for performance based design of structures to resist disproportionate collapse. This has coincided with an increased ability of high fidelity numerical analysis tools validated by experimental...

Progressive Collapse Analysis of Existing Buildings – A Performance Based Approach

by Applied Element Method | Mar 3, 2017 | Conferences

The paper describes the complexity of the seismic assessment and rehabilitation of three different existing buildings in New Zealand. The assessment was performed using Progressive Collapse Analysis. This method has been materialized into explicit requirements for...

Performance-Based Seismic Vulnerability Evaluation Of Existing Buildings In Old Sectors Of Quebec

by Applied Element Method | Jul 20, 2010 | Other Publications, Thesis

Masonry is a construction material widely used around the world. Although its poor behavior under seismic loads has been extensively reported, masonry is used in earthquake prone areas mainly due to its relatively low cost. In order to improve the seismic performance...

Categories

  • Bulletins
  • Conferences
  • Journals
  • Other Publications
  • Thesis
  • Uncategorized

Recent Posts

  • Reliability of collapse simulation – Comparing finite and applied element method at different levels
  • Research and Practice on Progressive Collapse and Robustness of Building Structures in the 21st Century
  • Using the Applied Element Method to simulate the dynamic response of full-scale URM houses tested to collapse or near-collapse conditions
  • The Applied Element Method and the modelling of both in-plane and out-of-plane response of URM walls
  • Using the applied element method for modelling calcium silicate brick masonry subjected to in‐plane cyclic loading

Archives

  • Applications
  • Publications
  • Resources
  • Contact
  • Policies
  • RSS
© 2004-2020 Applied Element Method | Powered by AEM - Advanced Nonlinear Dynamic Numerical Analysis